MTSPF6.6K 200A V6 Based Controller 12S 50V SUPERFOC ESC

Notice:

This VESC is not stock item, if you're interested we can still do for you, contact us for more information.

Specification:

Notice:NeverconnectonereclevertotwoormoreV6/V75basedSUPERFOCESCsorVESCsinanarray!PermanentdamagemayresultfromY-PPMwiring.
OnlyconnectCANLandCANH!GNDpinsand5VshouldneverbeconnectedinaV6/V75basedSUPERFOCESCsorVESCarray.

Attention Points when you receive the controller Please:
All products had been double checked and tested one by one before shipment, only if the products are working normally would be shipped out.

• • When you receive the controller, please test without load and do not connect motor, first check if thecontroller can successfully connect to your computer, if ok, then connect to motor and you can start to adjust parameters.
  • Do not use switching power supply, the instant voltage when switching power supply connect tocontroller is very high, which would easy damage the controller.
  • Do not push the throttle too hard when test without load, gently and slowly speed up.
  • Be cautious when adjust parameters, if parameters set mistake, would also easy damage the controller.
  • Please must remember to change to corresponding modes when you adjust parameters, for example, the VESC default mode is BLDC mode, but if you want to detect FOC mode and adjusted FOC parameters, at this time if mode in VESCTOOL didn't change to FOC mode, then when you push throttle, would easy burn the controller, same as FOC mode.
  • In FOC mode, ERPM suggest to control in 30000-40000; In BLDC moed, ERPM suggest to control in 50000-60000, otherwise driver IC would easy to be damaged. ERPM= motor pole pairs number * KV * Voltage
    ERPM= motor pole pairs number * KV * Voltage
  • If you use UART port, the wire better do not over 0.5m or even shorter, and better use Stranded wire.
  • For V4 based controller:

  Do not suggest to use FOC mode, suggest to use BLDC mode.
  If need to use FOC mode, then must use voltage under 20V.

  • The above are only suggestions based on the experience of our engineers. how to actually operate is up to you. Parameters for different setup is also different, please noted

Application:Electric skateboard, Esk8, Eskate, Elongboard, Mountainboard, Offroad skateboad, All terrain skateboard, Eskate, E-bike, Electric bike, Electirc motorcycle, E-scooter, Electric scooter, motorized skateboard, ROV/RPVEE, Remote operated vehicles, underwater robots, Underwater robotics, Underwater remotely operated vehicles, Subsea robots, Cablecam, Cable camera, Broadcast, IBC2019, Ultra drones, Security monitoring robots, Robots for security and safety monitoring in harsh terrain, Agile robots, Autonomous agile robots, Security robots, Autonomously monitor security, Combat robots, Fighting robots, Electric surfboard, Efoil, etc.,

V5 Bluetooth Module:

V2 Bluetooth Module:

Recommend Products: Click below pictures to check more information

Brushless Outrunner Motors: